Good day:
After reading thru the posts, it's my understand that once BD is installed, it may take a few days for Autoscan to complete for the first time. And the completion will be logged in the Events log.
When I first installed BD, the hard drive was VERY active mostly all the time. I let the PC set idle for hours and now the drive has settled down.
My question is: (Acutally, I'm not sure what the real question is but.....) What causes Autoscan to start again, or more specifically, what causes it to determine that it has completed?
If Autoscan is always running, how does it know it's completed?
Also (ok, I had more than one question) what is the threshold that either starts or stops Autoscan?
When you boot up the PC, where does Autoscan start it's scan? From the beginning or the last file it scanned when shut down?
