Scan tasks custom tasks don't work

RobJH
edited September 2017 in General


Hi,


In Total security 2018 custom scans are not working, I setup a scan just to scan a specific folder on the C drive on system startup (Email folder) and I set to aggressive.


When I try and run this scan from manage scan tasks it starts scanning all of drive C even though it's not checked under scan targets, also if I edit the scan it is always reset to normal scan from the aggressive setting.

Comments


  • Bump, Anyone?


  • I've found that their whole scan function is a hot mess.  Custom scans that I set up to just scan a particular drive were still scanning all drives.  I tried deleting those custom scans but they still keep running.  Now I have 2 or 3 scans running at the same time and there doesn't seem to be any way to stop or cancel them. 

Featured content

bitdefender review banner

Romance Fraudster in UK to Spend 2 Years Behind Bars

A serial romance fraudster was sentenced to 28 months in prison for conning several women out of £20,000.

Read more
bitdefender review banner

Europol Shuts Down Hackers’ Favorite VPN Service

Europol earlier this week coordinated joint action to take down VPNLab.net.

Read more
bitdefender review banner

Top Five Security Tips for Mac Users in 2022

In this simple guide, we look at five basic cybersecurity hygiene practices every Mac user should read, and use,in 2022.

Read more