Protection - Malware/ Firmware/etc.
Protection - Malware/ Firmware/etc.
Too many notifications when an application attempts to connect to the Internet.
Hello everybody,
I was using ESET Internet Security for over a decade, and a few months ago I changed to Bitdefender Total Security. I am quite pleased with it, except one major problem which annoys me often.
I want to fully control the access of my applications to the Internet, so I have enabled the alert mode of the firewall settings. It works fine, until I have to leave the pc unattended for a few minutes. Then the Bitdefender Firewall notification pops up and prompts me to Allow or Block a connection. When I return to the computer, I have to click on the Allow or Block button a few thousand times to make the notification disappear!
I had the same settings in ESET and when a new or changed application was attempting to connect to the Internet, ONE click was enough either to Allow or Block the connection.
Why can’t be the same with Bitdefender and I need to click a few thousand times to get rid of the notification?
Is there a workaround other than disabling the Alert Mode?
In the video below, I estimate that I have clicked over 2.500 times without any result, so I had to restart the computer to get rid of the notification.
Best regards,
Best Answer
-
Kindly contact the bitdefender support by visiting https://www.bitdefender.com/consumer/support/ and scroll down to the bottom of the webpage where you can get in touch with support representative either by email, chat or over a call.
Alternatively, you can also share your feedback with bitdefender support team by dropping them an email at bitsy@bitdefender.com and asking them to share the same with the developers.
The support team will reply back to your query within next 24-48 hours excluding weekends.
Regards
Life happens, Coffee helps!
Show your Attitude, when you reach that Altitude!
Bitdefender Ultimate Security Plus (user)
2
